Camshaft Solenoid Valve – Honda CR-V Mk II – 2001-2007 – 15830RBB003

Get your Honda Cr-v MK II (2001–2007) back to smooth variable valve timing and full engine performance with this replacement VVT camshaft valve position sensor, also referenced in service manuals as the cam timing valve or VVT solenoid. Built to OEM specification, matching 15830-PNC-003, 15830-PNB-003, 15830-PNA-003, 15830-RBB-003 and 15830-RAD-Y01.

Common signs of failure

A failing VVT solenoid or oil control valve typically triggers the check engine light with codes P0010, P0011, P0014 or P0017 (intake/exhaust camshaft position and actuator circuit faults). Drivers report rough idle, hesitation under acceleration, reduced power, a distinct rattle from the top of the engine on cold start that fades as oil pressure builds, poor fuel economy, and in some cases the vehicle dropping into limp mode. Ignoring the fault can lead to timing chain wear.

Fitment notes

Plug-and-play installation, no diagnostic coding required. The solenoid controls oil flow to the camshaft phaser, so a worn or clogged unit causes the cam timing to lag — producing the symptoms above. Replacement is typically a short job: drain a small amount of oil, undo the retaining bolt, swap the solenoid, refit and clear codes. Standard 2 pin connector.

Frequently asked questions

Can I drive with a P0010 or P0011 fault code?

Short distances yes, but extended driving with a failed VVT solenoid will accelerate camshaft and timing chain wear because the cam timing is no longer optimised. Replace the solenoid promptly to avoid much costlier repairs.

Do I need to use OEM oil after fitting?

Use the engine's specified oil grade and change it on schedule — VVT solenoids fail most often because of dirty or sludged oil. Fresh oil at the correct viscosity is essential.

Will it fix a rattle on cold start?

Yes, if the rattle is caused by delayed phaser engagement due to a faulty solenoid. If the rattle persists after fitting, the camshaft phaser itself may also need replacement.